LED Driver

Product Details:

INPUT CHARACTERISTIC:INPUT OPERATING VOLTAGE : 100VAC-300VAC.INPUT FREQUENCY : 47Hz to 63Hz.INPUT CURRENT : <250mA RMS @100VAC.EFFICIENCY : >85% Under Maximum load @ 230VAC.POWER FACTOR : >0.90 at all line conditions.THDi. : <20% at all line conditions.
OUTPUT CHARACTERISTIC:OUTPUT VOLTAGE : 40VDC.OUTPUT CURRENT : 300mA ± 20mA Constant Current.OUTPUT WATTAGE : 12W ± 5%.LINE & LOAD REGULATION : ± 5%.
PROTECTIONS:OVER TEMPERATURE PROTECTION : The driver is protected against over temperature. when the junction temperature on the driver chip die rises to 150ºC, the driver willshutdown immediately and will remain switched off until thetemperature on die falls to 130ºC.OUTPUT OVERLOAD/SHORT CIRCUIT PROTECTION : The driver is protected against over load & short circuit . During over load & Short circuit the driver will go to hick upmode and resumes to normal operation on removal of fault condition.OUTPUT OVER VOLTAGE PROTECTION: In case of output load open the driver output will limit the voltage to safe levels and will work normally when the load is connected back.this will not create any hard failures in the driver.
TERMINATIONS:AC INPUT : Input 2core 100mm length cable.DC OUTPUT : Output 2core 100mm length cable.MECHANICAL:PCB DIMENSIONS : Length 66mm, Width 31mm

Product Details:

PROTECTIONS

• PROTECTION AGAINST CONTROL CKT. FAILURE

 

PRODUCT SAFETY

• DI-ELECTRIC VOLTAGE WITHSTAND TEST 3KVAC rms, 50Hz for one minute (trip current set at 5mA). Between Shorted INPUT and Shorted OUTPUT Terminals
• INSULATION RESISTANCE When tested with a 500VDC Megger shall be > 100 M ohms Between Shorted INPUT and Shorted OUTPUT Terminals

 

RELIABILITY & QUALITY

• COMPONENT DERATING FACTORS All Semiconductors Junction Temperature Shall is not Exceeded the Manufacturer's Maximum Thermal Rating

 

EMI / EMC

• SURGE IMMUNITY As per Test standard IEC61000 - 4 - 5
• Test Level 3 +/- 2KV in Differential Model
• ELECTRICAL FASTTRANSIENTS As per Test standard IEC61000 - 4 - 4 Test Level 3 2KV
• ESD As per Test standard IEC61000 - 4 - 2. Test Level 3 Air discharge 8KV. Test Level 3 Contact Discharge 6KV

 

TERMINATIONS

• AC INPUT AC 2core Blue and Brown 160mm Length, cable other end directly solder to PCB
• DC OUTPUT DC 2core Grey and Black 160mm Length, cable other end directly solder to PCB

 

OUTPUT CHARACTERISTICS

• NOISE< 240mV. Pk-Pk, at Nominal Input (measured with 0.1F ceramic disc & 10F Electrolytic capacitor across output in 20 MHz bandwidth oscilloscope)

 

ENVIRONMENT

• TEMPERATURE Operation Ambient 0C to + 50C ambient. Storage -15C to + 70C ambient
• HUMIDITY Operating 5% RH to 95% RH non-condensing. Storage 5% RH to 95% RH non-condensing

 

 

Product Details:

INPUT CHARACTERISTIC:INPUT OPERATING VOLTAGE : 100VAC-300VAC.INPUT FREQUENCY : 47Hz to 63Hz.INPUT CURRENT : <250mA RMS @100VAC.EFFICIENCY : >85% Under Maximum load @ 230VAC.POWER FACTOR : >0.90 at all line conditions.THDi. : <20% at all line conditions.
OUTPUT CHARACTERISTIC:OUTPUT VOLTAGE : 60VDC.OUTPUT CURRENT : 300mA ± 20mA Constant Current.OUTPUT WATTAGE : 18W ± 5%.LINE & LOAD REGULATION : ± 5%.
PROTECTIONS:OVER TEMPERATURE PROTECTION : The driver is protected against over temperature. when the junction temperature on the driver chip die rises to 150ºC, the driver willshutdown immediately and will remain switched off until thetemperature on die falls to 130ºC.OUTPUT OVERLOAD/SHORT CIRCUIT PROTECTION : The driver is protected against over load & short circuit . During over load & Short circuit the driver will go to hick upmode and resumes to normal operation on removal of fault condition.OUTPUT OVER VOLTAGE PROTECTION: In case of output load open the driver output will limit the voltage to safe levels and will work normally when the load is connected back.this will not create any hard failures in the driver.
TERMINATIONS:AC INPUT : Input 2core 100mm length cable.DC OUTPUT : Output 2core 100mm length cable.MECHANICAL:PCB DIMENSIONS : Length 66mm, Width 31mm.

Product Details:

INPUT CHARACTERISTIC:INPUT OPERATING VOLTAGE : 140VAC-300VAC
(Withstand Voltage up to 320VAC) INPUT POWER : 24W ± 5%.INPUT FREQUENCY : 47Hz to 63Hz.INPUT CURRENT : <200mA RMS @140VAC.EFFICIENCY : >85% @ 230VAC.POWER FACTOR : >0.95 @ 230VAC.THDi. : <20% @ 230VAC.
OUTPUT CHARACTERISTIC:OUTPUT VOLTAGE : 67V - 75VDC.OUTPUT CURRENT : 300mA ± 50mA Constant Current. LINE & LOAD REGULATION : ± 5%.
PROTECTIONS:OVER TEMPERATURE PROTECTION : The driver is protected against over temperature. when the junctiontemperature on the driver chip die rises to 150ºC, the output powerand thermal dissipation are also reduced.OUTPUT OVERLOAD/SHORT CIRCUIT PROTECTION : The driver is protected against over load & short circuit .During over load & Short circuit the driver will go to hick up mode and resumes to normal operation on removal of fault condition.OUTPUT OVER VOLTAGE PROTECTION  : In case of output load open the driver output will limit the voltage to safe levels and will work normally when the load is connected back.this will not create any hard failures in the driver.

SURGE PROTECTION:6KV

TERMINATIONS:AC INPUT : 3Core, 0.50Mtr Length open Wires.DC OUTPUT : 2Core, 0.10Mtr Length open Wires.
MECHANICAL:DRIVER DIMENSIONS : Length: 75.00mm, Width: 43.00mm, Height: 27.00mm.

INPUT CHARACTERISTIC:INPUT OPERATING VOLTAGE : 140VAC-300VAC 
(Withstand Voltage up to 320VAC) INPUT POWER : 36W ± 5%.INPUT FREQUENCY : 47Hz to 63Hz.INPUT CURRENT : <350mA RMS @140VAC.EFFICIENCY : >85% @ 230VAC.POWER FACTOR : >0.95 @ 230VAC.THDi. : <10% @ 230VAC.
OUTPUT CHARACTERISTIC:OUTPUT VOLTAGE : 50V - 55VDC.OUTPUT CURRENT : 700mA ± 50mA Constant Current. LINE & LOAD REGULATION : ± 5%.
PROTECTIONS:OVER TEMPERATURE PROTECTION : The driver is protected against over temperature. when the junctiontemperature on the driver chip die rises to 150ºC, the output powerand thermal dissipation are also reduced.OUTPUT OVERLOAD/SHORT CIRCUIT PROTECTION : The driver is protected against over load & short circuit .During over load & Short circuit the driver will go to hick up mode and resumes to normal operation on removal of fault condition.OUTPUT OVER VOLTAGE PROTECTION  : In case of output load open the driver output will limit the voltage to safe levels and will work normally when the load is connected back.this will not create any hard failures in the driver.

SURGE PROTECTION:6KV

TERMINATIONS:AC INPUT : 3Core, 0.50Sq.mm Cable.DC OUTPUT : 2Core round 0.40 Sq mm Cable.
MECHANICAL:DRIVER DIMENSIONS : Length: 106.00mm, Width: 75.00mm, Height: 31.00mm.

Additional Information:

• Minimum Order Quantity: 1000 Piece

INPUT CHARACTERISTIC:
INPUT OPERATING VOLTAGE : 140VAC-300VAC
(Withstand Voltage up to 320VAC)
INPUT POWER : 36W ± 5%.
INPUT FREQUENCY : 47Hz to 63Hz.
INPUT CURRENT : <400mA RMS @140VAC.
EFFICIENCY : >84% @ 230VAC.
POWER FACTOR : >0.95 @ 230VAC.
THDi. : <10% @ 230VAC.
OUTPUT CHARACTERISTIC:
OUTPUT VOLTAGE : 68V - 75VDC.
OUTPUT CURRENT : 600mA ± 50mA Constant Current.
LINE & LOAD REGULATION : ± 5%.
PROTECTIONS:
OVER TEMPERATURE PROTECTION : The driver is protected against over temperature. when the junctiontemperature on the driver chip die rises to 150ºC, the output powerand thermal dissipation are also reduced.
OUTPUT OVERLOAD/SHORT CIRCUIT PROTECTION : The driver is protected against over load & short circuit .During over load & Short circuit the driver will go to hick up mode and resumes to normal operation on removal of fault condition.
OUTPUT OVER VOLTAGE PROTECTION : In case of output load open the driver output will limit the voltage to safe levels and will work normally when the load is connected back.this will not create any hard failures in the driver.

SURGE PROTECTION:6KV

TERMINATIONS:
AC INPUT : 3Core, 0.50Mtr Length open Wires.
DC OUTPUT : 2Core, 0.17Mtr Length open Wires.

MECHANICAL:

DRIVER DIMENSIONS : Length: 124.00mm, Width: 67.00mm, Height: 39.00mm.

Additional Information:

• Minimum Order Quantity: 1000 Piece

INPUT CHARACTERISTIC:INPUT OPERATING VOLTAGE : 140VAC-300VAC 
(Withstand Voltage up to 320VAC) INPUT POWER : 60W ± 5%.INPUT FREQUENCY : 47Hz to 63Hz.INPUT CURRENT : <500mA RMS @140VAC.EFFICIENCY : >84% @ 230VAC.POWER FACTOR : >0.95 @ 230VAC.THDi. : <10% @ 230VAC.
OUTPUT CHARACTERISTIC:OUTPUT VOLTAGE : 68V - 75VDC.OUTPUT CURRENT : 750mA ± 50mA Constant Current. LINE & LOAD REGULATION : ± 5%.
PROTECTIONS:OVER TEMPERATURE PROTECTION : The driver is protected against over temperature. when the junctiontemperature on the driver chip die rises to 150ºC, the output powerand thermal dissipation are also reduced.OUTPUT OVERLOAD/SHORT CIRCUIT PROTECTION : The driver is protected against over load & short circuit .During over load & Short circuit the driver will go to hick up mode and resumes to normal operation on removal of fault condition.OUTPUT OVER VOLTAGE PROTECTION  : In case of output load open the driver output will limit the voltage to safe levels and will work normally when the load is connected back.this will not create any hard failures in the driver.

SURGE PROTECTION:6KV

TERMINATIONS:AC INPUT : 3Core, 0.20Mtr Length open Wires.DC OUTPUT : 2Core, 0.20Mtr Length open Wires.
MECHANICAL:DRIVER DIMENSIONS : Length: 124.00mm, Width: 67.00mm, Height: 39.00mm.

Additional Information:

• Minimum Order Quantity: 1000 Piece

INPUT CHARACTERISTIC:INPUT OPERATING VOLTAGE : 140VAC-300VAC 
(Withstand Voltage up to 320VAC) INPUT POWER : 72W ± 5%.INPUT FREQUENCY : 47Hz to 63Hz.INPUT CURRENT : <600mA RMS @140VAC.EFFICIENCY : >84% @ 230VAC.POWER FACTOR : >0.95 @ 230VAC.THDi. : <10% @ 230VAC.
OUTPUT CHARACTERISTIC:OUTPUT VOLTAGE : 70V - 78VDC.OUTPUT CURRENT : 0.90A to1.0A Constant Current. LINE & LOAD REGULATION : ± 5%.
PROTECTIONS:OVER TEMPERATURE PROTECTION : The driver is protected against over temperature. when the junctiontemperature on the driver chip die rises to 150ºC, the output powerand thermal dissipation are also reduced.OUTPUT OVERLOAD/SHORT CIRCUIT PROTECTION : The driver is protected against over load & short circuit .During over load & Short circuit the driver will go to hick up mode and resumes to normal operation on removal of fault condition.OUTPUT OVER VOLTAGE PROTECTION  : In case of output load open the driver output will limit the voltage to safe levels and will work normally when the load is connected back.this will not create any hard failures in the driver.

SURGE PROTECTION:6KV

TERMINATIONS:AC INPUT : 3Core, 0.30Mtr Length open Wires.DC OUTPUT : 2Core, 0.30Mtr Length open Wires.
MECHANICAL:DRIVER DIMENSIONS : Length: 130.00mm, Width: 76.00mm, Height: 43.00mm.

Additional Information:

• Minimum Order Quantity: 1000 Piece

Product Details:

INPUT CHARACTERISTIC:INPUT OPERATING VOLTAGE : 100VAC-300VAC.INPUT FREQUENCY : 47Hz to 63Hz.INPUT CURRENT : <250mA RMS @100VAC.EFFICIENCY : >85% Under Maximum load @ 230VAC.POWER FACTOR : >0.90 at all line conditions.THDi. : <20% at all line conditions.
OUTPUT CHARACTERISTIC:OUTPUT VOLTAGE : 72VDC.OUTPUT CURRENT : 240mA ± 10mA Constant Current.OUTPUT WATTAGE : 18W ± 5%.LINE & LOAD REGULATION : ± 5%.
PROTECTIONS:OVER TEMPERATURE PROTECTION : The driver is protected against over temperature. when the junction temperature on the driver chip die rises to 150ºC, the driver willshutdown immediately and will remain switched off until thetemperature on die falls to 130ºC.OUTPUT OVERLOAD/SHORT CIRCUIT PROTECTION : The driver is protected against over load & short circuit . During over load & Short circuit the driver will go to hick upmode and resumes to normal operation on removal of fault condition.OUTPUT OVER VOLTAGE PROTECTION: In case of output load open the driver output will limit the voltage to safe levels and will work normally when the load is connected back.this will not create any hard failures in the driver.
MECHANICAL:PCB DIMENSIONS :Length 110mm, Width 17mm,HEIGHT 12mm

Additional Information:

• Minimum Order Quantity: 500 Piece